1/5/2023 0 Comments Sidechain studio one 3![]() Either the VC instrument doesn't expose a sidechain sort of input or Presonus Studio One doesn't recognize what sort of input the VC instrument is exposing. Jbdiver wrote:The problem with trying to calibrate using the VC instrument is that there doesn't seem to be a way to get the incoming audio from my synth back to the virtual instrument. I think that exposing this sidechain input would certainly make the calibration process easier. Perhaps there is some other bug in Presonus which is not allowing users to see the sidechain input on the VC instrument. OS, I wasn't able to load the VC 2.0 instrument in Presonus Studio One 2.x until the most recent Presonus update. I figured out an easier way to set this up. The steps I outlined earlier in this thread are too complicated. You only need to patch into port 1 and port 2 on the es-3 to do the calibration.ĭoes this all make sense? I really should put together some quick videos explaining how to setup these configurations. Now, as long as you can calibrate your external synth with a pitch-cv and gate signal you should be okay. So when you assign the VC effect to a track, you can only use the first two outputs from the VC effect - unlike the VC instrument which creates its own virtual output interfaces. You can't create something like a 5.1 track. The only downside that I remember is that Presonus Studio One doesn't support anything other than mono or stereo individual tracks. You can use the voice controller effect to calibrate your synth because the effect can output calibration voltages AND it can also receive audio input (like any other effect). So, the VC instrument works fine as an output-only device on Presonus, but it cannot be used for calibration. My understanding is that if a sidechain input were available, I would be able to configure a send to that sidechain input In Studio One. The problem with trying to calibrate using the VC instrument is that there doesn't seem to be a way to get the incoming audio from my synth back to the virtual instrument. I am able to use the voice controller as an instrument once I can load the calibration profiles. Here's the deal.īasically, I had to use the voice controller as an _effect_ when calibrating my synths. I just haven't used the es-3 in the past 6 months, and I was confused when looking at my old songs. Yikes.Īnyway, most of what I said before in this thread is BS. It took me three hours to figure out that I was inadvertently sending channel 3&4 on the ADAT port to channel 1&2. These internal mixer settings can make troubleshooting the es-3 a nightmare. Note to anyone using an RME card: be very careful when configuring the totalmix settings. I'm using the first ADAT port on my RME HDSP interface card to connect to the es-3. Okay, I spent several hours with studio one and the es-3 today.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |